Page 1 of 1
Early Mark 1 2.0 Prestige Manifold wanted
Posted: Tue Jan 27, 2015 5:22 pm
by very tall brad
For a 1992 8v non turbo 2.0 XM. Mine has a crack. I think it's repairable but I could do with a spare, just in case, please.
Am I thinking these will be the same as on a Xantia?
Re: Early Mark 1 2.0 Prestige Manifold wanted
Posted: Tue Jan 27, 2015 7:00 pm
by Dean
Brad these are specific to the xm engine with Bosch and I think magnetti management pug used a different setup as did the xantia.
D
Re: Early Mark 1 2.0 Prestige Manifold wanted
Posted: Tue Jan 27, 2015 7:06 pm
by citroenxm
Ive just checked Service Citroen, and YES the exhaust manifold is the same as ALL 8v ONLY Xantia Mk.1 Engines (UP TO 1997)
16 v manifolds are different!
Re: Early Mark 1 2.0 Prestige Manifold wanted
Posted: Tue Jan 27, 2015 7:52 pm
by Dean
I Should just give up with this, useless
Yes the Exhaust manifold is common across all 8v lumps using the same block with between 1.6 and 2.0 displacement, they are well known for cracking. 8v xantias are a bit thin on the ground now, you do get the odd 205gti one come up for sale if they have had the stainless 421 manifold upgrade but because cracking is common finding one may take a little while, unless your near that white breaker?
Again as Paul says 16v heads dont fit as they had 8 exhaust ports with tubular headers rather than the cast afair the 8v got.
D
Re: Early Mark 1 2.0 Prestige Manifold wanted
Posted: Tue Jan 27, 2015 7:55 pm
by citroenxm
I noticed the 8v manifolds are available on xantias HOWEVER the 16v manifolds are NFP....
Re: Early Mark 1 2.0 Prestige Manifold wanted
Posted: Tue Jan 27, 2015 7:58 pm
by Dean
That is surprising.
D
Re: Early Mark 1 2.0 Prestige Manifold wanted
Posted: Tue Jan 27, 2015 9:55 pm
by very tall brad
Thanks, I'll see what I can find in some French breaker yards where there are hundreds of Xantias and XMs.
Re: Early Mark 1 2.0 Prestige Manifold wanted
Posted: Wed Jan 28, 2015 7:08 am
by citroenxm
If that's the case you do well to buy a good few and stock them ready for the next person!!
Posted: Wed Jan 28, 2015 7:15 pm
by Eddie nuff
or at least pass on the info.