Citroen XM Forum

Hi All
Have had no joy getting my driver's side window to go up or down...decided to bite the bullet and pull it out of door
It has a 9 pin connector (someone has been into it before) judging by the silicone sealant unless Citroen bought a job lot of that in the 90s

Cable is all in place, nicely wrapped and tension springs seem good

Firstly...Please can anyone out there tell me which of the 9 terminals to apply power to ...to simply get the thing to operate or not as the case may be.

If it doesn't operate would anyone know where I can source a replacement ?
Thanks for reading

Per Gabor's Series-2 wiring diagrams. viewtopic.php?f=13&t=7592&start=110#p132408

Power is supplied to the unit on Pins-5, 6, 9, Gnd on Pin-1, but the internal controller supplies either forward, or reverse power to the motor, depending on which input receives a +ve input. Pins 8&4 are manual operation, pin-2 is auto up, pin-3 is auto down.

Thanks Dieselman
Appreciate your time
Will get into it over weekend and let you know how I get on
Thanks
Paul