Citroen XM Forum

Hi,

I'm after a Series 1 non EGR exhaust manifold, I would think it's needs to be from a 1992 or older engine.

Thanks.

Steve.

Phhooooorrrrr thats gonna be a hard find Steve!

I assume for your SED?

Ill keep ears open and let you know if I hear anything.

Paul

I think the early 406s used them - there are a lot more of those about.

Peter

Ignore this I read 'inlet'

You should be able to just remove the EGR valve from the manifold, and make up a little blanking plate to fit in its place.

That actually, Johnathan, worked well on a Xantia I did..

I swapped a Turbo from a 1997 EGR equpit car to a 1996 non, and made and bolted a blanking plate..

Caused no problems at all!

We also plugged the inlet manifold too... all worked fine!

Paul

I was intending originally to go along the blanking plate route until I found out earlier cars didn't have EGR but if they are rare then a plate it will be.

Thanks all.

Steve.