Technosir charging rig
Posted: Tue May 31, 2011 8:31 pm
Does anyone have a sphere recharging rig they are looking to get rid of?
D
Citroen XM Forum
The global resource for Citroen XM owners
https://club-xm.co.uk/Forum/
Technosir charging rig
Page 1 of 2
Re: Technosir charging rig
Posted: Tue May 31, 2011 9:17 pm
................Finished with tartan paint and including a free bag of rocking horse poo too?
D
D
Re: Technosir charging rig
Posted: Tue May 31, 2011 9:20 pm
Yes, and while we are at it, anyone got a hydraulics pressure test kit they want to be rid of as well? 
Re: Technosir charging rig
Posted: Tue May 31, 2011 9:21 pm
A sphere pressure tester is quite buildable DIY, mine didnt cost me too much either!
Re: Technosir charging rig
Posted: Tue May 31, 2011 9:22 pm
Oh noooo,ive got one you could borrow if you like though Will.....
D
D
Re: Technosir charging rig
Posted: Tue May 31, 2011 9:26 pm
Dave. I intend to build a sphere pressure test kit from a pump and regulator I have.
Dean.
Yes please as I would like to test my cars.
Dean.
Yes please as I would like to test my cars.
Re: Technosir charging rig
Posted: Tue May 31, 2011 9:30 pm
Where are you? i will PM you about it tomorrow.
D
D
Re: Technosir charging rig
Posted: Tue May 31, 2011 9:37 pm
Since we are on requests, anyone got a pipe flare kit and some pipe 
?
I need to make a couple of pipes for the CX.
?I need to make a couple of pipes for the CX.
Re: Technosir charging rig
Posted: Tue May 31, 2011 9:49 pm
Not found the rocking horse poo yet but sourced some nitrogen.
Insurance problems about bringing it to shows though.
Sphere tester was well worth the effort of setting up.
Can borrow the kit to make up pipes in the two small sizes.
John
Insurance problems about bringing it to shows though.
Sphere tester was well worth the effort of setting up.
Can borrow the kit to make up pipes in the two small sizes.
John
Re: Technosir charging rig
Posted: Tue May 31, 2011 9:56 pm
I need to remove the rear suspension cylinders from a CX. The pipes have been replaced, and the nut is turning, but the pipe is turning with the nut, and is going to wring off. I was hoping for an easy option of sticking in a short bridge from the original pipe to the cylinder, which has been done on the CX Athena.