Page 1 of 1
Wanted NSF door glass edge strip
Posted: Wed Jun 24, 2015 8:08 am
by Dieselman
I need the door edge to glass weatherstrip for the outside of a NSF door. I foolishly removed mine to paint the door and the inner section split away.
Re: Wanted NSF door glass edge strip
Posted: Wed Jun 24, 2015 9:57 am
by jeastham
Dieselman wrote:I need the door edge to glass weatherstrip for the outside of a NSF door. I foolishly removed mine to paint the door and the inner section split away.
I believe I could help you out, here.
Justin
Re: Wanted NSF door glass edge strip
Posted: Wed Jun 24, 2015 10:14 am
by Dieselman
Can you get it off without it splitting?
There is a retaining nut at the rear edge, inside the door then it would be best to press it up from below, with the glass removed.
Re: Wanted NSF door glass edge strip
Posted: Wed Jun 24, 2015 1:39 pm
by jeastham
Dieselman wrote:Can you get it off without it splitting?
There is a retaining nut at the rear edge, inside the door then it would be best to press it up from below, with the glass removed.
Not keen on removing the glass just yet; but the motor is removed; so I'm guessing I can drop the glass right down
Re: Wanted NSF door glass edge strip
Posted: Wed Jun 24, 2015 3:00 pm
by Dieselman
The glass will need to go below the normal lowest height, so will need to be unclipped. From there removal is a 30 second job, just tilt it and pull it up out of the door.
Re: Wanted NSF door glass edge strip
Posted: Wed Jun 24, 2015 5:39 pm
by southerner
You know where I am if you get stuck.
Re: Wanted NSF door glass edge strip
Posted: Wed Jun 24, 2015 8:28 pm
by Dieselman
Have you got one in good nick?
Re: Wanted NSF door glass edge strip
Posted: Wed Jun 24, 2015 9:04 pm
by MTXM
I also have several of these already off cars Will and I will be at the National if you can wait until then. With regards, Matthew T.
Re: Wanted NSF door glass edge strip
Posted: Thu Jun 25, 2015 4:30 pm
by southerner
bit og green stuff on them but the look fine