PRV V6 exhausts!

[Assich]

markysimon here is a link to how I replaced that Y section.

viewtopic.php?f=13&t=2275" onclick="window.open(this.href);return false;

[MTXM]

Yes P.D Gough are the company to approach if you need assistance. I found the cost of a hand made steel system comparable with the earlier aftermarket components I had purchased when still available. Regards, Matthew T.

[Dieselman]

P.D Gough systems may be good, but when the price for a piece of stainless pipe with two 45 degree bends in goes from £200 over the phone, to £400 when you get there, it's time to think again.

Mr Tyre charged £100 for the same kind of pipe bent and welded to the cat while I waited.

[markysimon]

If you have a "Mr Tyre" centre near you, they will make any part of a stainless exhaust system for you while you wait.

They once made me a link pipe welded onto the back of my existing cat, for a reasonable sum.

PD Gough haven't responded (yet), but I have now contacted a Mr Tyre depot fairly near me – well 30 miles away – who quoted me (approx) £450 for the cat back system, plus another £200 for the cats. Are they any good?

And does MTXM have details of the Latvian autofactor who is still listing the system?

[MTXM]

The costs that you have obtained from Mr Tyre certainly seem reasonable and Will (Dieselman) had good experience with the Company. Unfortunately the Latvia supplier did not respond and the parts listed were anyway S1 V6. Regards, Matthew T.