Page 1 of 1
WANTED: PRV6-24 dipstick
Posted: Wed Jan 31, 2018 7:34 pm
by Dieselman
Can anyone supply either a dipstick, or accurate measurements of a later PRV6-24 dipstick.
Re: WANTED: PRV6-24 dipstick
Posted: Wed Jan 31, 2018 7:47 pm
by Dean
Is it routed differently to the 12v do you know?
D
Re: WANTED: PRV6-24 dipstick
Posted: Wed Jan 31, 2018 8:02 pm
by Dieselman
Dean wrote:Is it routed differently to the 12v do you know?
D
Not according to Service Citroen. be aware there was a P/n change at RP5200.
Re: WANTED: PRV6-24 dipstick
Posted: Wed Jan 31, 2018 8:55 pm
by Dean
Ah the increased oil capacity issue?
I can measure mine at the weekend for you, i tried in vain to find a new dipstick but could find no direct replacement and everything else was either too wide to fit the guide tube or too short so i bought one with the correct size handle, cut it open and bonded it to my existing stick.
D
Re: WANTED: PRV6-24 dipstick
Posted: Wed Jan 31, 2018 8:59 pm
by Dieselman
On mine the rubber top has disintegrated and the bung slides up and down. I can make a top, but need to know the correct length, though I can guage that pretty well anyway.
Measurements would be useful. Is yours pre or post mod?
Re: WANTED: PRV6-24 dipstick
Posted: Wed Jan 31, 2018 9:10 pm
by Dean
I cannot remember, i don't know what car the engine came from, i would need to check the engine number, but it is a 2975cc so earlier lump, engine number FV700042091
D