Page 4 of 4
Re: Bits and bobs
Posted: Fri Jul 12, 2019 7:48 pm
by Dieselman
xmexclusive wrote: ↑Fri Jul 12, 2019 6:11 pm
Hi Will
As I understand apart from the pipe thread size strut heads have identical geometry.
The change is effected at the bottom end.
Details are given:-
Section 7 of the workshop manual (book 058932) sheets XM 410-00/1 page 2.
This shows the plate markings on the alloy baseplate.
Difference is by plate casting angle.
Non hydractive plates are marked with a number 4 on the top of the plate.
Hydractive are marked with a number 1 on the top of the plate.
The plate holds the roll bar at the rear and the back end of the wishbone at its front.
The cast steel wishbone top clamp has a matching angle and similar marking.
Sorry no scanning facilities at present.
John
Got it!
I know the yolk you mean and have two that need the bolt drilling out, so will check the markings.
Note: Both ones I have where the bolt is so seized in that it snapped the head off rather than turn, are the drivers side (UK). This is because there is no protection from oil spill from the LHM tank and gearbox.
Do not try to drive the bolt out, or pry the yolk as being an alloy casting, it will snap.
Re: Bits and bobs
Posted: Wed Jul 17, 2019 8:38 pm
by Onion Johnny
Hello Dave, What sort of money are you wanting for two decent strut tops to fit a Series II 2.0tct 1997? How do you tell if the gaiter is the larger diameter one? May need these ae well.
Ian
Re: Bits and bobs
Posted: Sun Jul 28, 2019 8:49 pm
by davetherave
Ian- both of my decent strut tops have gone I do have strut rams/ gaitors left though.
Fredgeepm - here are some pics of calipers
Also a few pics of other bits that are left- John you mentioned locks- not sure if glove box ones are any good.
Glovebox is a mk 2 no airbag variant and the strut ram on it is full of beans.
Armrest is leather and bit next to it is motor for electric version may be useful if you want to convert to electric armrest.
20190728_212906.jpg
20190728_211937.jpg
20190728_211927.jpg
20190728_205636.jpg
20190728_204902.jpg
Re: Bits and bobs
Posted: Wed Jul 31, 2019 1:00 pm
by davetherave
More bits,also realised missed a couple of pics from above!
20190731_133809.jpg
20190731_133759.jpg
20190731_132758.jpg
20190731_131325.jpg
Re: Bits and bobs
Posted: Wed Jul 31, 2019 1:03 pm
by davetherave
Re: Bits and bobs
Posted: Wed Jul 31, 2019 1:06 pm
by davetherave
20190727_162617.jpg
20190727_162642.jpg
20190728_104535.jpg
Re: Bits and bobs
Posted: Thu Aug 01, 2019 2:19 pm
by Woodie
Have sent a PM ta
