xm 2ltr turbo s1 sei

demario · Post by **demario** » Sun Mar 15, 2020 5:42 pm

hi can anybody with pin out diagram for bosch engine ecu many thanks

White Exec · Post by **White Exec** » Sun Mar 15, 2020 11:05 pm

Pin-out details are included in this document...
viewtopic.php?f=13&t=7592&start=70#p115087
See Engine, petrol 2.0

Covers the rest of the car, too.
The PDF can be downloaded and printed.

Post by **Dieselman** » Mon Mar 16, 2020 7:59 am

Keep us informed as to how you are getting on with your fixes, as we can probably help you out further as you go.

demario · Post by **demario** » Mon Mar 16, 2020 9:18 am

Hi thanks for your help i need series 1 ecu pin outs not s2 which i have im trying to locate inertia switch wiring or switch location many thanks

Post by **Dieselman** » Mon Mar 16, 2020 9:20 am

demario wrote: ↑
Mon Mar 16, 2020 9:18 am
Hi thanks for your help i need series 1 ecu pin outs not s2 which i have im trying to locate inertia switch wiring or switch location many thanks

There isn't an inertia switch on a Series 1 car.

What exactly is the problem?

demario · Post by **demario** » Mon Mar 16, 2020 9:44 am

Hi fuel pump not switched on from 807 relay pin 3 from ecu not connected to ground if i connect a wire to pin 3 and ground pump works and engine fires up i fitted s/h ecu still the same fault

White Exec · Post by **White Exec** » Mon Mar 16, 2020 2:25 pm

Demario, if you can post your RP number, I'll dig out the correct circuit diagram for your injection ECU.

Post by **Dieselman** » Mon Mar 16, 2020 2:59 pm

I think the attached should contain the correct diagrams for you.

The diagram for engine codes RFZ using Motronic 3.1 shows the fuel pump to be controlled by relay 816, which is fed +12v from relay 807 receiving power from the Ign switch and Gnd.

Relay 816 is controlled by the ECU Pin 20 going to Gnd.

Firstly, check you have all the appropriate power feeds and Gnd for the ECU to function, then read the fault codes and go from there.

Obviously the ignition and fuel side of the system work, as you can force it to run.

demario · Post by **demario** » Mon Mar 16, 2020 4:35 pm

hi rp no 5936 runs with bosch ecu 0 262 200 219 96 182 194 80

White Exec · Post by **White Exec** » Mon Mar 16, 2020 7:22 pm

Thanks for the RP number. The circuits I have here don't go back far enough, so I hopefully Will's (Dieselman's) document will help.

Citroen XM Forum

xm 2ltr turbo s1 sei

xm 2ltr turbo s1 sei

Re: xm 2ltr turbo s1 sei

Re: xm 2ltr turbo s1 sei

Re: xm 2ltr turbo s1 sei

Re: xm 2ltr turbo s1 sei

Re: xm 2ltr turbo s1 sei

Re: xm 2ltr turbo s1 sei

Re: xm 2ltr turbo s1 sei

Re: xm 2ltr turbo s1 sei

Re: xm 2ltr turbo s1 sei