Gasa XM 2.1 "Prestige"

[Gasa]

The difference in resistance is that it probably got warm from holding it in your hand, as the sensor heats up, the resistance changes.
...I will also have to see that connector on the door, sometimes it shows the right temperature quite normally and after some time it starts to count down with a big minus and at the end a line appears on the display, and only lines appear during the day.

[Dieselman]

There should be an O ring sealing the hinge connector, but if the conector has been parted previously it's possible the O ring is displaced, allowing water in.
Electric window and central locking faults can sometimes be attributed to that connector.

Regarding the Climate Control operation, please see attached information.
It states that the selected temperature is retained after Ign off, but doesn't say how that is achieved, whether by backup power, or NvRam.
The default is 22c, so anything other than that has been stored.

See thread in "Self Help" files.
viewtopic.php?f=13&t=10604

[Gasa]

...for now I'm just collecting parts, the weather is still bad, as soon as the weather gets warmer, the installation will follow.

IMG_20230303_102904.jpg

IMG_20230303_110023.jpg

IMG_20230303_110611.jpg

IMG_20230303_111423.jpg

IMG_20230308_193025.jpg

IMG_20230308_193339.jpg

IMG_20230315_191138.jpg

[Gasa]

...always, on all models, grease must be added for lubrication, very little is added during assembly.

IMG_20230301_113447.jpg

IMG_20230301_113517.jpg

IMG_20230301_115330.jpg

IMG_20230301_115338.jpg

[Dieselman]

That's a healthy selection of new parts, the car should be like new once done.

I'm interested as to which brand of suspension arm compliance bushes you have purchased, as often they don't fit the spigot very well, they tend to be too loose.
Can you please accurately measure the inside bush diameter

[Gasa]

..the measurements are the same on all 4 silen blocks, the blocks are Febi brand.

IMG_20230316_171923.jpg

IMG_20230316_172044.jpg

IMG_20230316_172200.jpg

IMG_20230316_172339.jpg

IMG_20230316_172426.jpg

IMG_20230316_172454.jpg

I will see when I install them if the measurement is good.

[Dieselman]

19.?? mm
Any chance of an image of the complete vernier scale.
Also can you please measure the wishbone.



They should be an interference fit with the wishbone stub.

Your car is a series 2 and usually the new bushes don't seem to fit the Series 1 wishbones and there are two part numbers for bushes, but all suppliers cross reference them to the same supplied item.
I'm trying to see if the wishbones themselves changed diameter, hence the later bushes only fit later wishbones.

[Gasa]

When I take everything apart I will see if they fit, if they are not the same I will replace them.

[Gasa]

..the rear disks also arrived, now everything is complete.

IMG_20230319_181720.jpg

IMG_20230319_181829.jpg

IMG_20230319_181758.jpg

[Gasa]

I noticed that when I turn the steering wheel left and right, at normal speed, the servo reacts well, the steering wheel goes smoothly, but when I turn quickly to the left, the steering wheel is much harder to turn to the right, as if there is no servo, I don't know if it is due to the pump or the old oil.