Page 56 of 60
Re: Rob's SED Now V6 Exclusive
Posted: Fri Oct 30, 2015 10:07 pm
by ragger
That is Jim's opinion too!
Whilst the rear is being dropped to accommodate the pipework, I going to have new rear spheres fitted. Fronts will follow in due course when funds allow. Although Pleiades spheres are not the cheapest, it seemed sensible to order them at the same time so that the work will not be held up.
Re: Rob's SED Now V6 Exclusive
Posted: Fri Oct 30, 2015 10:15 pm
by russ92xmsed
AHHH, snap. I'm planning on getting the rears done too. All of them are up for replacement, four years old now, but to me, the back is the worst.
Re: Rob's SED Now V6 Exclusive
Posted: Fri Oct 30, 2015 10:46 pm
by xmexclusive
Hi Rob
Is there an anti-sink sphere as well?
If so it is on the top one end of the subframe.
Very easy to do while dropped, hard work otherwise.
John
Re: Rob's SED Now V6 Exclusive
Posted: Fri Oct 30, 2015 10:47 pm
by MTXM
Best exhaust note ever!
Apart from the S1 XM 24v of course!!
Regards,
Matthew T.
Re: Rob's SED Now V6 Exclusive
Posted: Sat Oct 31, 2015 3:07 pm
by russ92xmsed
Whilst driving, yes, totally agree. But the Xantia only needs to be sitting idling, and it sounds wonderful....
Re: Rob's SED Now V6 Exclusive
Posted: Sat Oct 31, 2015 10:37 pm
by MTXM
The PRV 24v sounds pretty good idling too Russ!! I am not sure about the Xantia, but the XM ESJ is hardly audible when ticking over, that is also quite impressive I guess. Regards, Matthew T.
Re: Rob's SED Now V6 Exclusive
Posted: Tue Nov 03, 2015 10:20 pm
by ragger
Piping and rear spheres arrived today - very rapid service from Pleiades.
Fitting to follow...
Re: Rob's SED Now V6 Exclusive
Posted: Wed Nov 04, 2015 9:26 am
by MTXM
That is good news Rob and I have always found Pleiades to be very helpful and efficient. Do let us know how you get on with the fitting. With regards, Matthew T.
Re: Rob's SED Now V6 Exclusive
Posted: Tue Dec 15, 2015 4:23 pm
by ragger
Well vast sums of money have been spent and lots of new pipes are in place along with the four rear spheres. However, it doesn't stop there... there is a leak from the pressure regulator, but exactly where from I am not sure. Are regulators available to purchase either new or reconditioned does anyone know, and if so how much?
Re: Rob's SED Now V6 Exclusive
Posted: Tue Dec 15, 2015 6:12 pm
by normanlindley
Hi Rob,
Ring Plaides, Martin replaced my regulator a couple of years ago for a refurbished unit.
Norman