Hello Chaps....new owner

Post by **citroenxm** » Wed Apr 07, 2021 7:53 am

potential head swap then.. use yur exsisting block and swap heads..

Stickfinger · Post by **Stickfinger** » Wed Apr 07, 2021 8:06 am

Yep....that is the plan

Stickfinger · Post by **Stickfinger** » Thu Apr 15, 2021 4:13 pm

After a lot of "home" delays and a 90th birthday......the cylinder head is off the spare engine.

20210415_154243.jpg

20210415_154231.jpg

Post by **Dieselman** » Fri Apr 16, 2021 7:10 am

That head looks fine, but check for flatness before committing to fit it.
I would lap the valves in even if it doesn't require machining.

Keep that old head gasket with the block as it shows the thickness is three hole.
On Xud engines, the head gasket thickness is a result of piston protrusion, not the cylinder head, which is flat.

Stickfinger · Post by **Stickfinger** » Sat Apr 17, 2021 11:15 am

Ordered:

New Cy'ldr bolts
3 & 4 notch HG's (4 notch was cheap so will cover me if a skim is needed)
Complete engine rebuild gasket set including new valve stem seals
Intake manifold joining "tubes/cuff's"

Washing/degreasing/jet wash flushing today

Post by **Dieselman** » Sat Apr 17, 2021 11:30 am

Stickfinger wrote: ↑
Sat Apr 17, 2021 11:15 am
Ordered:

New Cy'ldr bolts
3 & 4 notch HG's (4 notch was cheap so will cover me if a skim is needed)

Technically you don't need to fit a thicker gasket if skimming, as the head is flat. The gasket thickness is to allow for different piston protrusion, which doesn't change when skimming.
I can't see the compression ratio changing much unless the head is skimmed very deeply.

What thickness gasket is fitted to the original engine?

Stickfinger · Post by **Stickfinger** » Sat Apr 17, 2021 11:30 am

OK, I have a spare then

Citroen XM Forum

Hello Chaps....new owner

Re: Hello Chaps....new owner

Re: Hello Chaps....new owner

Re: Hello Chaps....new owner

Re: Hello Chaps....new owner

Re: Hello Chaps....new owner

Re: Hello Chaps....new owner

Re: Hello Chaps....new owner