A TcT head off job

[citroenxm]

I shall do a simple update on this.. but we got the car all back together and running.. and it ran nicely..

While i was at it i was asked to look at the cruise control as it didnt work.. so i did some pin checks.. at the ecu and they checked ok. I powered the vac pump and it did work however gave no vaccum. So wheel arch liner out on passenger side and a look at the vac pipes.. they happened to be all intact and connected.. so.. i removed the vac pipe from the bellow and blew back down it and could hear air leakage.. so i decided to remove the vac assey from the car for a closer look..

Upon blowing i found air leaking from the dump valve.. however this is normal as it defaults to normally open for safty reasons.. applying 12v to it a few times actually got it working again and it appeared it had got a bit sticky from lack of use. The idea is you activate the cruise and thus it shuts and dump valve and builds the vaccum up.. hence the delay when you first activate the cruise...

So feeling confideant i put it all back together and went for a drive.. lo and behold the speedo stopped working again so there was no cruise again.. so as per other topic i got another speed sensor.. fitted it and went down the road and hey presto.. the cruise worked again! Jobs a guddun..

So once again another xm resurrected and returned to its owner.. and so.. onto the next.. which im not sure which way to go.

[Dean]

jobs a good'un then Paul.

D

[MTXM]

.. onto the next.. which im not sure which way to go.

Is that the S2 V6 auto-manual conversion Paul? Regards, Matthew T.

[citroenxm]

Could be... or could it be lpg install on a 1.6 petrol peugeot 307... or it could be a gearbox swap on a 54 plate xsara picasso or it could be installing some hdi injectors in a 55 plate c5 2.0 16v hdi .. or it could be a flow divider on a 2.1 td xm ... or it coukd be a patch on a cill on a G reg xm sed or it could be a couple of patches on my own v6 24v xm .. or it could be a wiper motor swap on a xantia exclusive or a wiring fault between A pillar and drivers door on the same car.. or it could be a cruise control install on a series 1 xm td .. or on a xantia hdi ... or.. it could be continueing on a s2 v6 auto to manual xm....

[White Exec]

Ops Room.jpg

We do need keeping up-to-date, you know...

[citroenxm]

Could be... or could it be lpg install on a 1.6 petrol peugeot 307... or it could be a gearbox swap on a 54 plate xsara picasso or it could be installing some hdi injectors in a 55 plate c5 2.0 16v hdi .. or it could be a flow divider on a 2.1 td xm ... or it coukd be a patch on a cill on a G reg xm sed or it could be a couple of patches on my own v6 24v xm .. or it could be a wiper motor swap on a xantia exclusive or a wiring fault between A pillar and drivers door on the same car.. or it could be a cruise control install on a series 1 xm td .. or on a xantia hdi ... or.. it could be continueing on a s2 v6 auto to manual xm....

Ha.. thats still all to do as well as a day job!

[raynoon]

Paul... you've missed a couple of jobs out...

[White Exec]