Does anyone have one of these

[Ken Newbold]

I'm sure you'll all know what it is, but if you're lucky enough not to, I'll explain.

Yesterday evening at 4.40pm in the centre of Barnsley I heard and felt that sickening bang as my clutch pedal hit the floor
I managed to get the car home to find this part of the clutch cable had gotten fed up and gave up. Looking at it, it's obviously been on it's way out for some time as two of the cracks are fresh and two are dirty.
Luckily my spare cable was the right one and about an hour later it was fitted and the car up and running again. What worries me is that the one I've fitted also had some wear in it.
So I wondered if you've had a cable snap on yours, did you keep this part, as my cables are fine and I'd like to make a good cable out of two bad ones.

[Dieselman]

You can see where that has been fractured for some time on the outer part.

Is the clutch particularly heavy? Having fitted a new clutch and taken care to clean all the bearings, etc, mine is now so light the over-centre spring holds it down for a fraction of a second when fully depressed.

[colinxm]

If there's enough interest I could make up a batch of these in either aluminium or stainless - should last forever

Anyone interested ?

Colin.P

[messerschmitt owner]

If there's enough interest I could make up a batch of these in either aluminium or stainless - should last forever

Anyone interested ?

Colin.P

Colin

if the same part fits a diesel 2.1TD, I would buy one as a spare

[davetherave]

Colin

if the same part fits a diesel 2.1TD, I would buy one as a spare

I second that!

Or would if i had a clutch!

[Ken Newbold]

Me too this is from a 2.1 diesel.

[messerschmitt owner]

Me too this is from a 2.1 diesel.

R544?
R543 is MoT'd and will be taxed for next week.
Seriously, if you make them, we will buy them!

[jorgy]

Count me in.
George

[colinxm]

Hi all, I think I have a cable from a BE3 equiped car in the loft to work from but obviously don't know if it's the same as the later ME5 type cables . can anyone confirm or send me a sample of the later type quadrant for comparison ? I shouldn't think it will be different but with being Citroen one never knows...

As soon as confirmed orders reach the 10 off mark I'll get programming and tooled up so can any serious members please confirm either here or by pm and I'll get cracking

Cheers, Colin.P

[Ken Newbold]

I can send you this one as a sample if you like One thing to point though, it has a needle roller bearing down the made pivot, but I suppose a brass bush or something would be almost as good.