Paul's 2.1Sd manual K47BAN. The early years.
-
- Could do a 2.1 headgasket
- Posts: 1109
- Joined: Fri Aug 09, 2013 8:11 pm
- Location: Near Warrington
Re: Paul's 2.1Sd manual COMPLETE. The Work Continues....
Wooo! You still off travelling next week then Paul??
-
- Global Moderator
- Posts: 9987
- Joined: Wed Apr 15, 2009 9:11 am
- Location: North Wales - FAR far far away!!! :-p
Re: Paul's 2.1Sd manual COMPLETE. The Work Continues....
Nope will, plans have changed now!
Projects:(eventually if theres any bodywork left)
93 L Xm 2.1t D auto project
93 L xm V6 12v Sei Manual
Others
In use.. 1995 M reg S2 2.1td auto exclusive
93 L Xm 2.1t D auto project
93 L xm V6 12v Sei Manual
Others
In use.. 1995 M reg S2 2.1td auto exclusive
- CitroJim
- Citroen God!
- Posts: 3730
- Joined: Wed Apr 15, 2009 4:43 am
- Location: North Bucks
- Contact:
Re: Paul's 2.1Sd manual COMPLETE. The Work Continues....
I had my planned leave cancelled at short notice Willcitroenxm wrote:Nope will, plans have changed now!

Jim
'98 Saxo
'95 AX
Three bikes - Road, Aero and TT
Ex- owner of several XMs and many Xantias!
'98 Saxo
'95 AX
Three bikes - Road, Aero and TT
Ex- owner of several XMs and many Xantias!
-
- Global Moderator
- Posts: 9987
- Joined: Wed Apr 15, 2009 9:11 am
- Location: North Wales - FAR far far away!!! :-p
Re: Paul's 2.1Sd manual COMPLETE. The Work Continues....
Managed a few hours on the XM today. Engine plummed back in, bolted in place.. drive shafts in.. new accumilator sphere fitted... rads fitted .. water in with 3.5 litres of anti freeze, not sure if thats enough or not.
Ran up to temp.. all ok.



Here is, I hope a THIRD start, the first two were used for bleeding the fuel system up. So effectically a "First Start".. Bear in mind theres no inlet manifold fitted here... (CLICK image to View vid)

So, wednesday, headlight surround to fit, front bumper to fit, final check over and try for another MOT on her.
Ran up to temp.. all ok.



Here is, I hope a THIRD start, the first two were used for bleeding the fuel system up. So effectically a "First Start".. Bear in mind theres no inlet manifold fitted here... (CLICK image to View vid)

So, wednesday, headlight surround to fit, front bumper to fit, final check over and try for another MOT on her.
Projects:(eventually if theres any bodywork left)
93 L Xm 2.1t D auto project
93 L xm V6 12v Sei Manual
Others
In use.. 1995 M reg S2 2.1td auto exclusive
93 L Xm 2.1t D auto project
93 L xm V6 12v Sei Manual
Others
In use.. 1995 M reg S2 2.1td auto exclusive
- CitroJim
- Citroen God!
- Posts: 3730
- Joined: Wed Apr 15, 2009 4:43 am
- Location: North Bucks
- Contact:
Re: Paul's 2.1Sd manual COMPLETE. The Work Continues....
Gosh, good work Paul
Excellent and good luck with the MOT. I'm sure it'll fly through..

Jim
'98 Saxo
'95 AX
Three bikes - Road, Aero and TT
Ex- owner of several XMs and many Xantias!
'98 Saxo
'95 AX
Three bikes - Road, Aero and TT
Ex- owner of several XMs and many Xantias!
-
- Global Moderator
- Posts: 9987
- Joined: Wed Apr 15, 2009 9:11 am
- Location: North Wales - FAR far far away!!! :-p
Re: Paul's 2.1Sd manual COMPLETE. The Work Continues....
So, the general run down that what has been done.
Front Disks and Pads.
Rear pads
Rear spheres
Free up rear suspension linkage rod.
Rear end of exhaust
New Clutch
New Multi layer steel gasket
Swapped off side caliper due to siezing on
New Cam belt and Water Pump
New Altinator belt
New HP Pump belt
New Regulator sphere
Welded both out riggers at the front
Checked rear subframe pipe work, all looked well and been sprayed with Spray Underseal
Remove Dash, to free up heater air flow flaps now lovly and free.
New heater matrix
Replaced right Hand display (Clock) for a non bleeding LCD Clock
The upshot of all this is ive enjoyed dooing all this but wont get the pleasure of trying it all out for long. However, I should feel confidant that she should give the new onwer some good service.
Front Disks and Pads.
Rear pads
Rear spheres
Free up rear suspension linkage rod.
Rear end of exhaust
New Clutch
New Multi layer steel gasket
Swapped off side caliper due to siezing on
New Cam belt and Water Pump
New Altinator belt
New HP Pump belt
New Regulator sphere
Welded both out riggers at the front
Checked rear subframe pipe work, all looked well and been sprayed with Spray Underseal
Remove Dash, to free up heater air flow flaps now lovly and free.
New heater matrix
Replaced right Hand display (Clock) for a non bleeding LCD Clock
The upshot of all this is ive enjoyed dooing all this but wont get the pleasure of trying it all out for long. However, I should feel confidant that she should give the new onwer some good service.
Projects:(eventually if theres any bodywork left)
93 L Xm 2.1t D auto project
93 L xm V6 12v Sei Manual
Others
In use.. 1995 M reg S2 2.1td auto exclusive
93 L Xm 2.1t D auto project
93 L xm V6 12v Sei Manual
Others
In use.. 1995 M reg S2 2.1td auto exclusive
- russ92xmsed
- Global Moderator
- Posts: 5733
- Joined: Mon Jun 11, 2012 5:23 pm
- Location: Cheltenham
- Contact:
Re: Paul's 2.1Sd manual COMPLETE. The Work Continues....
All looks great Paul. Best of luck. Sure it will pass.
Russ
1992 K reg XM 2.1 Auto SED RP 5712
1992 K reg XM 2.1 Auto SED RP 5705 (D)
Also
2003 C5 2.2 HDI Exclusive
I sell Engine bay, 1990 COTY, Total & Club XM Sticker Decals
http://www.rjwcreativedesign.co.uk
1992 K reg XM 2.1 Auto SED RP 5712
1992 K reg XM 2.1 Auto SED RP 5705 (D)
Also
2003 C5 2.2 HDI Exclusive
I sell Engine bay, 1990 COTY, Total & Club XM Sticker Decals
http://www.rjwcreativedesign.co.uk
- CitroJim
- Citroen God!
- Posts: 3730
- Joined: Wed Apr 15, 2009 4:43 am
- Location: North Bucks
- Contact:
Re: Paul's 2.1Sd manual COMPLETE. The Work Continues....
Gosh Paul, that's a hefty amount of work done... Didn't realise it amounted to that much 

Jim
'98 Saxo
'95 AX
Three bikes - Road, Aero and TT
Ex- owner of several XMs and many Xantias!
'98 Saxo
'95 AX
Three bikes - Road, Aero and TT
Ex- owner of several XMs and many Xantias!
- russ92xmsed
- Global Moderator
- Posts: 5733
- Joined: Mon Jun 11, 2012 5:23 pm
- Location: Cheltenham
- Contact:
Re: Paul's 2.1Sd manual COMPLETE. The Work Continues....
Hope your getting a sensible price for that lot. Loads of work there. Should be a good car.
Russ
1992 K reg XM 2.1 Auto SED RP 5712
1992 K reg XM 2.1 Auto SED RP 5705 (D)
Also
2003 C5 2.2 HDI Exclusive
I sell Engine bay, 1990 COTY, Total & Club XM Sticker Decals
http://www.rjwcreativedesign.co.uk
1992 K reg XM 2.1 Auto SED RP 5712
1992 K reg XM 2.1 Auto SED RP 5705 (D)
Also
2003 C5 2.2 HDI Exclusive
I sell Engine bay, 1990 COTY, Total & Club XM Sticker Decals
http://www.rjwcreativedesign.co.uk
- Eddie nuff
- Could do a 2.1 headgasket
- Posts: 1233
- Joined: Mon Feb 25, 2013 7:53 pm
- Location: West Yorkshire